end of the T-shaped siphon break into one end of the drain hose. First, shut of the power of the washing machine to ensure your safety. Also, spread some of the grease onto the threads on the wall plumbing and the connections on the washing machine. Adjust the form and the hose until at least 4 1/2 inches of hose, but no more than 8 inches, extends pass the end of the form. Install a washer drain hose siphon break above the 28-inch mark on the back of the washer. Search, add New Question, question, do I need to keep the tap running when using a pressure washer? They will be marked, so this should be easy. Pull the washer away from your wall until you have enough room to access the rear of the machine.
Finish by attaching these hoses to the corresponding inlets on the machine before turning on the water to test for leaks.
Step 2 Measuring the Fill Hoses.
Before you connect the water-supply hose to the plumbing, you should measure the distance from the tip of the washing machines hose to the plumbing to ensure the existing fill hose will reach.
Austin hookup reddit, The best hookup apps 2018,
Measure 28 inches from the floor along the rear of your washer. Attach the extension wand to the spray gun and tighten. Extending the Hose, to extend the length of the hose, purchase a hose that has the same diameter as the existing hose, but is longer, and then connect it using a connector. An improperly installed drain could result in water continually draining from the washer during the wash cycle. 5, turn on the water faucet, you do not want to run the high pressure water pump without a sufficient water supply, or the pump can be damaged. Use waterproof grease to coat all sides of the ring gasket. A coupler attachment twists on to the end of the garden hose.